kvr1333d3n9/8g 8gb 2rx8 1g x 64-bit pc3-10600 cl9 240-pin dimm description this document describes valueram's 1g x 64-bit (8gb) ddr3-1333 cl9 sdram (synchronous dram), 2rx8, memory module, based on sixteen 512m x 8-bit fbga components. the spd is programmed to jedec standard latency ddr3-1333 timing of 9-9-9 at 1.5v. this 240-pin dimm uses gold contact fingers. the electrical and mechanical specifications are as follows: features ? jedec standard 1.5v (1.425v ~1.575v) power supply ? vddq = 1.5v (1.425v ~ 1.575v) ? 667mhz fck for 1333mb/sec/pin ? 8 independent internal bank ? programmable cas latency: 9, 8, 7, 6 ? programmable additive latency: 0, cl - 2, or cl - 1 clock ? programmable cas write latency(cwl) = 7 (ddr3-1333) ? 8-bit pre-fetch ? burst length: 8 (interleave without any limit, sequential with starting address ?000? only), 4 with tccd = 4 which does not allow seamless read or write [either on the fly using a12 or mrs] ? bi-directional differential data strobe ? internal(self) calibration : internal self calibration through zq pin (rzq : 240 ohm 1%) ? on die termination using odt pin ? average refresh period 7.8us at lower than tcase 85c, 3.9us at 85c < tcase < 95c ? asynchronous reset ? pcb: height 0.740? (18.75mm) or 1.180? (30.00mm) document no. valueram1031-001.c00 03/26/15 page 1 memory module speci cations specifications s e l c y c 9 ) d d i ( l c row cycle time (trcmin) 49.125ns (min.) refresh to active/refresh 260ns (min.) command time (trfcmin) row active time (trasmin) 36ns (min.) maximum operating power tbd w* 0 - v 4 9 g n i t a r l u operating temperature 0 o c to 85 o c storage temperature -55 o c to +100 o c *power will vary depending on the sdram used. continued >> important information: the module defined in this data sheet is one of several configurations available under this part number. while all configurations are compatible, the dram combination and/or the module height may vary from what is described here.
module dimensions: document no. valueram1031-001.c00 page 2
|
